Electrical output in greenhouse
Electrical output in greenhouse
Looking to have a fan/heater/frost beater running in the greenhouse on the coldest nights and to help keep the air moving. The greenhouse is located near the garage rear door, about 3 metres from power socket.
I know the easiest option would be to run an extension cord from the garage to the greenhouse and just tidy the cable away from harms reach, but is this safe?
Greenhouses are a damp environment considering the condensation aspect. I'm worried about damp getting inside the plug/socket end of the extension.
What are most people doing to get their heater/fans rigged up in their greenhouses?
Have to find some time to get bubble wrapping in the next few days, mind you I am not too concerned about hard frosts yet. Hopefully we won't see those until after Xmas.
I know the easiest option would be to run an extension cord from the garage to the greenhouse and just tidy the cable away from harms reach, but is this safe?
Greenhouses are a damp environment considering the condensation aspect. I'm worried about damp getting inside the plug/socket end of the extension.
What are most people doing to get their heater/fans rigged up in their greenhouses?
Have to find some time to get bubble wrapping in the next few days, mind you I am not too concerned about hard frosts yet. Hopefully we won't see those until after Xmas.
Re: Electrical output in greenhouse
I'm not heating a greenhouse, but i have a permanent socket outside with a circuit breaker at the plug end.
Re: Electrical output in greenhouse
Probably be ok but as Darren says should be on either a breaker or a fused spur.
Re: Electrical output in greenhouse
Any electric running outside needs a circuit breaker fitted, also put a waterproof socket on the end of the lead in the greenhouse.
The fused spur is no good, it has to be a circuit breaker, some are fitted at the fuse board but if you have an older board then you must fit a breaker inside, either a plug in type or hard wired.
The fused spur is no good, it has to be a circuit breaker, some are fitted at the fuse board but if you have an older board then you must fit a breaker inside, either a plug in type or hard wired.
Re: Electrical output in greenhouse
You could get an armoured outdoor power kit for there Bob, they often come with a circuit breaker,and the extended end, has a flap that encloses whatever it is you choose to plug into it, and of course you'll have it in the greenhouse too, for added protection from the elements.
Re: Electrical output in greenhouse
One point though, if using a waterproof socket (and you should do so) then some of the moulded plugs wont let the lid shut fully and then you dont get the full waterproof seal.
You might need to cut off a moulded plug and rewire using a standard plug.
Like Nige said, you can buy the whole set up pre-wired with armoured cable from any DIY store but these are quite expensive.
You might need to cut off a moulded plug and rewire using a standard plug.
Like Nige said, you can buy the whole set up pre-wired with armoured cable from any DIY store but these are quite expensive.
Re: Electrical output in greenhouse
I'm going to buy the cable (heavy type) and plugs and put it together myself. I was going to buy some kind of tubing to put the cable through.
I'll check out my local hardware store for the waterproof socket and also a plugin breaker.
What kind of breaker rating should I be aiming for?
I'll check out my local hardware store for the waterproof socket and also a plugin breaker.
What kind of breaker rating should I be aiming for?
Re: Electrical output in greenhouse
No idea what rating, Im a carpenter not a sparky so as far as Im concerned then a circuit breaker is a circuit breaker
Re: Electrical output in greenhouse
I'm a sparky though , use M.K. Masterseal sockets and all your worries can be dismissed . (Personally I'd avoid any of the cheap 'n nasty own brand ones)
Re: Electrical output in greenhouse
I use something similar to thishttp://www.amazon.co.uk/Outdoor-Portabl ... B003O30KA0 with a circuit breaker at the main socket!
Re: Electrical output in greenhouse
Hmmm, I have both external waterproof sockets and an external feed powering outdoor lighting, both are on spurs (located inside) and both were fitted by qualified sparky`s. They go through a breakers on the circuit board one via downstairs socket ring and one via the conservatory socket ring.
Is this incorrect/ dangerous?
Is this incorrect/ dangerous?
- Dave Brown
- Site Admin
- Posts: 19742
- Joined: Sun Jul 09, 2006 10:17 am
- Location: Chalk, (Thames Estuary) Kent, England 51.5N 0.3E
- Contact:
Re: Electrical output in greenhouse
Having worked with mains most of my working life, had numerous 240v shocks, melted a metal jumper zip, while wearing the jumper , blown the ends off screwdrivers, and multimeter probes I am probably a bit more lax than most, but I won't say any more than that on here.
A trip is a must, not a fuse. The trip detects power going out, and not coming back.... which means it is going somewhere else and trips. There are different speeds, and I think 30ms is fairly standard now. A fuse blows when an overcurrent situation occurs. It is just these are very slow by comparison, and YOU will probably blow before the fuse does.
A trip is a must, not a fuse. The trip detects power going out, and not coming back.... which means it is going somewhere else and trips. There are different speeds, and I think 30ms is fairly standard now. A fuse blows when an overcurrent situation occurs. It is just these are very slow by comparison, and YOU will probably blow before the fuse does.
Best regards
Dave
_________________________________________________
Roll on summer.....
http://www.hardytropicals.co.uk
Dave
_________________________________________________
Roll on summer.....
http://www.hardytropicals.co.uk
Re: Electrical output in greenhouse
You may well have an RCD protected fuse board in which case youre covered, if not thenpdid wrote:Hmmm, I have both external waterproof sockets and an external feed powering outdoor lighting, both are on spurs (located inside) and both were fitted by qualified sparky`s. They go through a breakers on the circuit board one via downstairs socket ring and one via the conservatory socket ring.
Is this incorrect/ dangerous?
I finished full time kitchen fitting because the new 'part P' regs were just too much for a chippy to really comply with, also I couldnt be arsed to do the 17th edition as Im convinced its just another money making thing and the electrics I worked with just didnt warrant doing all the compliances that were required by a national kitchen company, mind you I know of plenty of sparks not 'part P' registered
Anyway thats an aside, garden electrics need to be made safe.
Re: Electrical output in greenhouse
Cheers Adrian, yeah I have an RCD on the CB so i`m covered phew
In most cases newly introduced regulations are all about making money. Basic electrics can be undertaken anyone with an ounce of common sense.
Having to be part p registered and provide safety certificates for changing a light switch or light fitting is quite frankly ridiculous.
In most cases newly introduced regulations are all about making money. Basic electrics can be undertaken anyone with an ounce of common sense.
Having to be part p registered and provide safety certificates for changing a light switch or light fitting is quite frankly ridiculous.
Last edited by pdid on Thu Oct 27, 2011 3:23 pm, edited 1 time in total.
- Dave Brown
- Site Admin
- Posts: 19742
- Joined: Sun Jul 09, 2006 10:17 am
- Location: Chalk, (Thames Estuary) Kent, England 51.5N 0.3E
- Contact:
Re: Electrical output in greenhouse
I inadvertantly found a way around part p, as it only applies to hard wired circuits. If the curcuit goes to a wired plug and socket it is regarded as an appliance. I just unplugged all my external electrics for part p testing
Best regards
Dave
_________________________________________________
Roll on summer.....
http://www.hardytropicals.co.uk
Dave
_________________________________________________
Roll on summer.....
http://www.hardytropicals.co.uk